Data Sheet

Slim fluorescent luminaire for 2 x 14W T16 lamps for surface mounted mounting. Body in white painted galvanized steel sheet with white plastic end caps and a clear acrylic diffuser. Keyhole fixing positions Ø14mm for direct mounting to ceiling or brackets. Fixing centres: 500mm. Two cable entries Ø19mm in the rear of the body and knockouts in the endcaps. Grommets included. Piano key terminals 5 x 2 x 2.5mm². Fitted with high frequency sensor connected to the corridor function on the gear, light output increases to 100% when you are detected and will dim down to 10% when you leave, suitable for corridors and staircases, range from 0.5m to approximately 4m at a ceiling height of 2.4m, switch off delay from 2 to 30 minutes, twilight photocell 2-2000 lux, coverage 360° with an opening angle of 160°. Please be aware, if used at maximum sensitivity, the sensor can detect through windows, doors and thin walls. The luminaire is not recommended to be placed outdoors or where material is moving, neither should it be exposed to vibrations. IP44 dust and moisture proof body extends application to canteens, cafeterias and kitchens. Can be suspended using wire suspension accessory (to be ordered separately. Lamps to be ordered separately.

Dimensions: 616 x 166 x 64 mm
Total power: 31 W
Weight: 1.6 kg
Luminaire efficacy: 64 lm/W

Mode selection
  • Lamp position:STD - standard
  • Light Source:2 x T16 / 14W
  • Luminaire luminous flux*:1975 lm
  • Lamp luminous flux:2 x 1200 lm
  • Luminaire efficacy*:64 lm/W
  • Lamp efficacy:77 lm/W
  • Colour Rendering Index min.:80
  • Ballast:1x HFI* Tridonic PCA T5 ECO lp
  • Luminaire input power*:31 W Power factor = 0.96
  • Standby Power*:0.2 W
  • Dimming:DALIDSI
  • Maintenance category:D - Enclosed IP2X
  • T16
  • CE
  • D
  • EAC
  • 650°
  • IP44
  • RCM
  • Electrical class I


Photometric configuration


Use CalcExpress to quickly carry out quick online calculations of required indoor luminaire numbers for rectangular rooms. Enter the calculation parameters for your solution such as room dimensions, mounting height, height of the useful plane and required level of illuminance, and the site will instantly suggest a solution according to the light output ratio method.

Step 1: Technical data
Step 2: Room Data
Step 3: Result